[ptx] Failed to build CVS

[Pablo d'Angelo]

Hi,

ah, sorry, I was playing with an experimental feature, and forget to
properly add all files to the CVS..

Pressing the "g" key on the Control Point tab will run a corner detector on
the left image (harris corner detector), and create control points at that
point. Based on the current transform between the two images, the locations
in the second image are computed.

There is no image processing done yet, but if the images fit well, they will
be close and it a "Finetune all points" can find the right locations for
most of them.

I suspect this is useful for distortion estimation, where many control
points might be needed.

But basically, its just a toy so far.

Jean-Luc Coulon (f5ibh) schrieb:
> I get the following:
> 
>         then mv -f ".deps/VigCorrDialog.Tpo" ".deps/VigCorrDialog.Po"; 
> else rm -f ".deps/VigCorrDialog.Tpo"; exit 1; fi
> make[3]: *** No rule to make target `wxPanoCommand.o', needed by 
> `hugin'.  Stop.make[3]: Leaving directory 
> `/source/hugin/hugin-0.5-cvs20060114-1/src/hugin'
> make[2]: *** [all-recursive] Error 1
> make[2]: Leaving directory 
> `/source/hugin/hugin-0.5-cvs20060114-1/src/hugin'
> make[1]: *** [all-recursive] Error 1
> make[1]: Leaving directory `/source/hugin/hugin-0.5-cvs20060114-1/src'
> make: *** [all-recursive] Error 1
> 
> Regards
> 
> Jean-Luc