[ptx] Autopano: No localization?

[Terje Mathisen]

There is a problem when using autopano together with PTAssembler, and 
being in a country where the decimal point is a comma:

autopano uses the C locale, which means that all control points are 
output with a '.' (period) before the fractional coordinates, while 
PTAssembler obeys the configured country locale and fails to accept any 
control points.

I've temporarily fixed this by setting my locale to the US, but I'd like 
to go back to the proper setup.

The best solution might be for all the program to accept both the C and 
the country locale for input, and output in the country locale?

Terje

-- 
- <Terje.Mathisen at hda.hydro.com>
"almost all programming can be viewed as an exercise in caching"
-------------- next part --------------


***********************************************************************
NOTICE: This e-mail transmission, and any documents, files or previous
e-mail messages attached to it, may contain confidential or privileged
information. If you are not the intended recipient, or a person
responsible for delivering it to the intended recipient, you are
hereby notified that any disclosure, copying, distribution or use of
any of the information contained in or attached to this message is
STRICTLY PROHIBITED. If you have received this transmission in error,
please immediately notify the sender and delete the e-mail and attached
documents. Thank you.
***********************************************************************